Stator + Flywheel + Gasket + Cap Coil fits Ski-Doo GSX GTX MX Z TNT 2009-2015

Description

Free
shipping in USA
Same day
shipping
visit our store >
find parts for :
ATV / UTV / SXS
Motorcycles
Snowmobiles
Watercraft
Other
Menu
Store Home
find parts for
ATV / UTV / SXS
Motorcycles
Snowmobiles
Watercraft
Other
Kit Stator + Flywheel + Gasket + Cap Coil for Ski-Doo Expedition Grand Touring GSX MXZ MX ZX Renegade 1200 cc 2009-2016
Brand New Kit Stator + Flywheel + Crankcase Cover Gasket + Ignition Cap Coil
Direct replacement to your original unit
Plug-and-play, direct fit, easy installation
All shipped products are tested
*All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.
Stator
Highest grade of lamination materials
Highest grade of copper winding, resistant to 200 degrees Celsius
Connector included
Rubber grommet included
Crankcase cover gasket included
Ignition Cap Coil
The Quality exceeds the OEM equipment
1 Cap coil included
If your old parts are defective,
RM Stator offer replacements parts of high qualities at a fraction of the cost of genuine parts.
*All item pictures are accurate, if in doubt, do not hesitate and compare our item to your original part.
Some Ski Doo models combine the spark plug caps and coils to reduce the number of parts used to improve efficiency. However, when your plug caps wear out is more expensive to replacing them. If you are experiencing ignition problems this could mean the coil plug cap needs replacing. The replacing was simple to do and help with the efficient running of your engine.
Magneto Flywheel Rotor
RMSTATOR is offering a new replacement flywheel for your Ski-doo. This flywheel can be used as a direct replacement to the OEM.
What is improved about the RM11503 flywheel?
Ski-doo 1200 snowmobiles are plagued with problems on the original flywheels. The additives in the motor oil were dissolving the epoxy that holds the magnets in the flywheel, causing them to detach and scatter throughout the engine.
The bad news is that by the time the problem occurred, no manufacturer would provide warranty repairs.
The good news is that RMSTATOR has manufactured a redesigned flywheel where the magnets are sealed in the flywheel, which reinforces the epoxy and prevents them from detaching. This new flywheel configuration corrects the problem permanently.
Dealership estimates to repair this failure are over 0 in parts alone. RMSTATOR offers you a high quality replacement part that corrects the problem for half the price. The RM11503 flywheel is not only a cost effective way to replace your failed Ski-doo flywheel, but a great investment when replaced before the failure occurs.
SEAL THAT PROTECTS THE MAGNET?S EPOXY FROM OIL ADDITIVES
Vehicle models fitment
Ski-doo Expedition 1200 SE TUV EFI L/C -- 2010-2016
Ski-doo Expedition 1200 TUV EFI L/C -- 2010-2016
Ski-doo Expedition 900 ACE EFI L/C -- 2016
Ski-doo Grand Touring 1200 EFI L/C -- 2010-2015
Ski-doo GSX 1200 EFI L/C -- 2009-2015
Ski-doo GTX 1200 EFI L/C -- 2009
Ski-doo MX Z 1200 Adrenaline EFI L/C -- 2010
Ski-doo MX Z 1200 EFI L/C -- 2009-2014
Ski-doo MX Z 1200 Renegade EFI L/C -- 2009
Ski-doo MX Z 1200 TNT EFI L/C -- 2011-2015
Ski-doo MX ZX 1200 EFI L/C -- 2009-2015
Ski-doo MX ZX 1200 Renegade EFI L/C -- 2009
Ski-doo Renegade 1200 Adrenaline EFI L/C -- 2010-2015
Ski-doo Renegade X 1200 EFI L/C -- 2010-2015
OEM part replacement
RM22871-R00
Specifications
Stator Dimensions
Interior diameter: 42 mm
Exterior diameter: 114 mm
Thickness: 19 mm
Length of wires stator to grommet: 110 mm
Length of wires grommet to plug: 600 mm
Other specifications:
Number of wires: 3
Number of plugs: 1
Number of pins: 3
Wire to wire resistance:
Alternator: Between each Yellow = 0.4 ohms +/-20%
Ignition Cap Coil Dimensions
Internal tube diameter : 22 mm
Flywheel Dimensions:
Exterior Diameter: 129 mm
Interior Diameter: 116 mm
Interior Diameter Center Housing: 30 mm
Exterior Diameter Center Housing: 38 mm
Thickness (exterior): 7 mm
Thickness (interior): 7 mm
instructions
Stator
Before installing your new stator
Check the AC output of the stator
Replace any burned or corroded connectors on stator and regulator/rectifier
Check and repair any melted wiring
Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
Magneto Flywheel Rotor
Before attempting to start your Ski-Doo adjusting the air gap is necessary.
Rotate the flywheel so the raised node is lined up with the pick up/pulser coil and adjust as close as possible but no less than 0.010"
SHIPPING
We deliver 99.4% of our orders within the specified time period. If your item is not available in our main Colorado facility, we still guarantee that your order will be delivered within the specified time period.
If your item is not delivered within this time period, we will offer you a 5.00$ discount on your order. This guarantee applies to shipments delivered in the 48 continental USA states, excluding PO boxes.
Videos
customer service
AsK seller a question
duties & taxes
International Buyers:
Import duties, taxes, and charges are not included in the item price
or shipping cost. These charges are the buyer's responsibility.
RaceTech Electric was founded in 2011 by three motorcycle industry veterans in San Diego, CA. The group has over 20 years combined in the Motorcycle industry.
Customer service
Part request
About us
About seller page
Add seller to favorite